Ultrasonic Body Sculpting Review: EMS Photon 7-in-1 System

 

Battling with cellulite at home seems like a never-ending quest for most women. We fight that cottage cheese like deposits of fat and waste trapped beneath the skin through diet, dry brushing, cellulite scrubs and oils to keep up with this problem the best we can. However, there is another option with ultrasonic body sculpting that you may want to explore such as the 7-in-1 Ultrasonic EMS Photon Body Sculpt System from GARYOB that I have been experimenting with.

**Disclaimer: This post has been compensated. Opinions are solely mine. **

Ultrasonic body sculpting works through a hand-held device using ultrasound energy to help break down the cellulite to tighten and reshape. Over time, the fat deposits burst to the point that the body will eventually and naturally eliminate the cellulite.

For the ultrasonic cavitation process, the 7-in-1 Ultrasonic EMS Photon Body Sculp System has a metal ultrasonic wave massage probe that you apply to your treatment area. Around that round metal center is the surrounding LED light area that you change the different types from red, blue, green to yellow, depending on what you’re trying to accomplish.

 

You get electrodes to attach from this ultrasonic body sculpting device to the skin as well as a power cable, gloves and an instruction book. However, you don’t get any clear skin care serum, lotion or cleansing gel that you need to use the unit.

To operate this unit, it is important to use a clear skin serum, cleansing lotion, firming or clear slimming skin care product before taking the metal center of this device to your skin and powering it up. The reason you need to apply that clear skin care product first is because it helps for the most thorough contact.

You can use this ultrasonic body sculpting device on the face or body just by changing the setting of the settings. You can the ultrasonic ion + (red light) or the ultrasonic ion – (blue light) when working with the face. I did not try this use yet on the face, but just on the body.

What I do for ultrasonic body sculpting is after I dried off after bathing, I put some clear moisturizing lotion I had on my hip area first. Next, I follow up by using this device turning on the ultrasound ion- (the red light) to massage the lotion in. I use circular motions from the center of the backside, gliding it slowly and eventually working upward for about 10 minutes so the product gets delivered and better contact before connecting the electrodes.

Don’t be in a rush to treat the area. Instead, you start on the lowest setting after attaching the electrodes before connecting the glove wire into the ultrasonic body sculpting device. The red light in that LED outer ring section should be visible. Afterwards, you just adjust the EMS mode that you want for the area. I advise to start experimenting on the lowest setting than working up to your comfort level. This ultrasonic body sculpting device fired up will work for 10 minutes at a time before turning itself off. You can always repeat the process.

Each time that you finish a session, make sure to adjust the mode to “no mode” and the intensity to “no intensity.”

Also, you don’t want to use any alcohol or water and soap to clean the metal center of this ultrasonic body sculpting device. The only way to care for this is using a soft cloth to wipe off any sticky residue from the clear skin care product you were using.

I have only used this a few times, but my goal is to work up to 30 minutes at a time of treating my problem area. So far, I haven’t noticed much difference except for a bit more smoothness over the hips. You just might say that I am a work in progress.

Have you tried any ultrasonic body sculpting devices yet? If you want were thinking of another way to combat cellulite, you just may want to give the 7-in-1 Ultrasonic EMS Photon Body Sculp System from GARYOB a try.  Look for this product on Amazon.